000 03201nam a2200313 a 4500
003 OSt
005 20240805102155.0
008 070517s19uu xx 00 eng d
040 _cCvSU Main Campus Library
041 _aeng
082 _a620.0042
_bL77 2002
100 1 0 _aLlamado, Jonathan V.
_eauthor
245 1 0 _aDesign and development of a microprocessor-based juice pouch filler and sealer /
_cby Jonathan V. Llamado an Girlie Q. Vidallo.
260 0 _aIndang, Cavite:
_bCavite State University- Main Campus,
_c2002.
300 _axiv, 58 pages :
_billustrations ;
_c28 cm.
336 _2rdacontent
_atext
337 _2rdamedia
_aunmediated
338 _2rdacarrier
_avolume
500 _aDesign Project (BS Computer Engineering) Cavite State University.
504 _aIncludes bibliographical references.
508 _aCollege of Engineering, and Information Technology (CEIT)
520 3 _aLLAMADO, JONATHAN V. and GIRLIE Q. VIDALLO. Design and Development of a Microprocessor — Based Juice Pouch Filler and Sealer. Undergraduate Design Project. Bachelor of Science in Computer Engineering. Cavite State University, Indang, Cavite. May 2002. Adviser: Mr. Bienvenido C. Sarmiento Jr. The Microprocessor-Based Juice Pouch Filler and Sealer was constructed and developed at Bancod, Indang , Cavite. The design project aimed to develop a system that will automatically fill and seal pouches. The project was composed of the pouch filler and sealer machine, control unit, motor driver unit, juice tank and the software. Assembly language was the programming language used in the development of the software. The machine was evaluated twice, preliminary and final evaluation. The final evaluation of the design project took place at the University Food Processing Center on April 16,2002 at 2 o’clock in the afternoon. It was done by conducting an actual filling and sealing of pouches using both the manual method and the proposed project. The pouches produced on both methods were counted and compared. Several questions and comments arose during the evaluation and the following were recommended: there should be a sensor in the loading section that will determine if the pouch is not loaded properly; use stainless juice tank instead of a plastic jag; provide a longer conveyor to load more pouches; there should be a counter to determine the number of filled and sealed pouches; and use a power back-up in case of power failure. Based on the results of the study, the machine, microprocessor circuit and the software were developed. It was therefore concluded that the Microprocessor-based Juice Pouch Filler and Sealer was able to fill and seal pouches automatically. It was also concluded that the machine was preferable to use than the existing manual method.
541 _cSubmitted copy for the University Library
_d
_eDP-74
650 _aEngineering
_xDesign
_9298
690 _91680
_aBachelor of Science in Computer Engineering
700 1 _aVidallo, Girlie Q.
_eauthor
856 _uhttp://library.cvsu.edu.ph/cgi-bin/koha/opac-retrieve-file.pl?id=7b44c378a79bb8daebc6873ca28a3701
_yClick here to view thesis abstract and table of contents
942 _2ddc
_cMAN
999 _c427
_d427