Development and construction of an improvised hydraulic press / by Jade Micole S. Batino, Eugenia P. Profeta Jr., and Romel I. Macalindong.
Material type: TextLanguage: English Publication details: Indang, Cavite: Cavite State University- Main Campus, 2006.Description: xix, 72 pages : illustrations ; 28 cmContent type:- text
- unmediated
- volume
- 629.23 B32 2006
- College of Engineering, and Information Technology (CEIT)
Item type | Current library | Collection | Call number | Materials specified | URL | Status | Notes | Date due | Barcode |
---|---|---|---|---|---|---|---|---|---|
Theses / Manuscripts | Ladislao N. Diwa Memorial Library Theses Section | Non-fiction | 629.23 B32 2006 (Browse shelf(Opens below)) | Link to resource | Room use only | DP-206 | 00001278 |
Design Project (BS Industrial Technology Major in Automotive Technology) Cavite State University.
Includes bibliographical references.
College of Engineering, and Information Technology (CEIT)
Batino, Jade Micole S., Macalindong, Romel I. and Profeta Eugenio P. Jr., Development and Construction of an Improvised Hydraulic Press. Bachelor of Industrial Technology major in Automotive Technology. Cavite State University, Indang, Cavite April 2005. Adviser: Eduardo J. Llanita
The Development and Construction of an Improvised Hydraulic Press was conducted in Tres Cruzes Tanza, Cavite. It was tested and evaluated at the College of Engineering and Information Technology on February 6 to 16, 2006. The study was conducted to show that it is possible to fabricate a Hydraulic Press that is low cost and can match the performance of commercially available pressing machine. The system has three major parts: the frame, the hydraulic jack and spring. The frame of the machine consists of posts, ram, and base. The machine design can be used as an alternative from commercially available pressing machine. Also it is a good instructional material in acquainting students on else of the press. The machine approximately weighs 400 kilograms and can release 15 tons of force needed to press fitted parts. Maximum stroke of the jack reaches approximately nine inches. The total cost of the project was Php. 28, 505. The only problem observed during testing is in adjusting the ram. It is recommended to install a motored pulley for easy adjustment of the ram.
06/16/2006 DP-206 Submitted to the University Library